Foster Laser Crafting

For SVG or DXF files of any of the original laser products below, please contact Bob Foster directly. Email

Please note that I only sell the SVG or DXF files for these designs so you can use them to create the objects using your own laser engraver/cutter. I do not sell the prepared wooden samples.

Note: A wider selection of my original designs is available on Creative Fabrica at my store.

Click any image for an enlargement.

Trivet A (5 Layers)
All trivet designs can also be used as coasters.

Trivet B (5 Layers)

Trivet C (5 Layers)

Trivet A Design Tray (4 Layers)

Stallion (4 Layers)
Please note that the top layer on this piece is extremely thin and It may not sut well on some lasers. Make sure your focus is set correctly, keep the size as large as possible (minimum 280mm), and handle the cut with care.

Geese in Flight (3 Layers)

Requires pasting the geese in place individually.

Ballerina (6 Layers)

Contemporary Dance (6 Layers)

Lakeside Sunset (4 Layers)

Paint Your Own Cuts - Mountain Scene

Obviously, I am not a painter, but you may be able to handle this one. Simply gather the cuts, paint them as you wish and reinsert them into the frame cut by the laser.

Sea Turtle (4 Layers)

Bunny Puzzle for Children (2 Layers)

Frame cut and stained black. Outer cut retained and stained. Interior puzzle pieces should be taken from a cut of the last image in the set. Those pieces have been made .5mm smaller to make placing them in position and then shaking them out to redo the puzzle much easier.

Webmaster